M-Audio MicroTrack II, User Manual

User Guide

19

MicroTrack II

Loop Playback

MicroTrack II will allow you to loop a section of an audio file. This can be useful when practicing parts or studying 
dictation. The method for looping a file requires setting a start and end point, and is accomplished as follows:

1.   To engage Loop Playback, press and hold the [MENU] button for over 2 seconds while the file is playing. The 

loop icon will appear on the lower left of the screen.

2.   Press the [MENU] button once when you reach the start point of the loop. A small “+” will appear to the left of 

the loop icon.

3.   Press the [MENU] button a second time when you reach the end point of your loop. The section will begin to 

loop immediately. A small “+” will appear to the right of the loop icon.

4.  Pressing the [MENU] button a third time will exit loop mode.

While using Loop Playback mode, you can:

< 

Adjust the playback volume using the [VOLUME] button.

< 

Delete the file by pressing the [DEL] button.

< 

Immediately begin recording a new file by pressing the [REC] Button.

< 

Fast-forward through the file by holding the [NAV] wheel up.

< 

Skip ahead to the next file by pressing up on the [NAV] wheel.

< 

Return to the beginning of a file by pressing down on the [NAV] wheel.

< 

Rewind the file by holding down the [NAV] wheel. 

< 

Pause playback by pressing in on the [NAV] wheel. Press in again to resume playback.

Additional [NAV] wheel functions when an audio file is paused in Loop Playback mode include:

< 

Return to a previous file by pressing down on the [NAV] wheel.

< 

Resume playback by pressing in on the [NAV] wheel.