29
9
Troubleshooting
9.1
Loud Feedback Heard After Launching NRV10
interFX
Ensure
that
the
Pre EQ/Post EQ button
of
the
NRV10
Mixer is pushed out/up before
launching NRV10 interFX.
If this button is pushed in/down when using NRV10 interFX,
you will experience feedback.
9.2
Noticeable Delay Between Input to the NRV10
Mixer, and Output from NRV10 interFX:
The cause of this issue is a high latency setting, and the remedy is to lower this setting.
For details on adjusting latency, see
Adjusting the Latency of the NRV10 Mixer
.
9.3
Crackles, Clicks, or Pops:
If at any time the audio output of NRV10 interFX produces crackles, clicks, pops, or other
artifacts, try the following:
•
Make sure no channels are clipping on the input of the NRV10 Mixer.
•
If the output of a channel in NRV10 interFX is clipping (signal reaches the top of a Level
Meter ), rotate the Gain Control of the channel counter-clockwise.
•
Crackles, clicks, pops, or other artifacts also occur when your computer cannot keep up
with the current task. To solve this problem, adjust the latency setting of the NRV10
interFX Mixer. See
Adjusting the Latency of the NRV10 Mixer
for more information.
9.4
Installed VST Plug-ins Are Not Available in
NRV10 interFX:
If your VST plug-ins are not available in NRV10 interFX, follow these steps:
1. Click the Options Button.
2. Choose "Preferences" from the resultant menu.
3. Click
the
Folders Tab
of the
Preferences Dialog
.
4. Using
the
Effect Folder Selector
, choose the location of your VST plug-ins.
