M
-BOX
Copyright Silca S.p.A 2016 - Vers.1
English
10
DEVICE CONNECTION
MECHANICAL CONNECTION
The M-BOX module is designed to be integrated with the following machines: RW4 Plus, FastCopy Plus,
Ezclone Plus, RW4 with P-BOX, FastCopy with P-BOX and Ezclone with Plus-BOX
Connecting to RW4 Plus, FastCopy Plus and Ezclone Plus
- Make sure the machine is turned o
ff
.
- Disconnect the power supply cable from the machine.
- Disconnect the RS-232 and/or USB communica on cables from the machine.
- Remove the four rubber feet on the bo om of the machine.
( Fig.4 )
- Place M-BOX on a bench with the pins
(A)
poin ng upwards.
- Fit the gaskets
(O)
onto the pins.
(Fig. 4)
- Place the machine on top of the M-BOX making sure the four pins enter the holes on the bo om of the
machine.
- Hold the devices together and turn upside down.
- Screw the screws
(P)
into the bo om of M-BOX and ghten well.
- Fit the four rubber feet into the holes on the bo om of M -BOX
.
Connecting to RW4 with P-BOX, FastCopy with P-BOX and Ezclone with Plus-BOX
IMPORTANT Notes:
- The RW4, FastCopy and Ezclone devices must have the P-BOX or Plus-BOX module in order to make copies
of Megamos® Crypto transponders.
- The M-BOX module must be placed between the RW4 (FastCopy/Ezclone) device and the P-BOX module.
- Make a note of the M-BOX device ID (Silca serial number and Mac-Address Wi-Fi) given on the labels
located under the device. These are necessary for the registra on of the M-BOX device.
- Make sure the machine and P-BOX module are o
ff
.
- Disconnect the power supply cable from the P-BOX module.
- Disconnect the power supply cable between the P-BOX module and machine.
- Disconnect the USB communica on cable from the machine.
- Disconnect the RS-232 serial communica on cable between the machine and P-BOX module.
- Remove the four rubber feet located on the bo om of the P-BOX module.
(Fig.5)
- Loosen the
fi
xing screws on the bo om of the P-BOX module.
(Fig.5)
- Carefully separate the P-BOX module from the machine.
(Fig.5)
- Place the M-BOX module on a bench with the pins
(A)
poin ng upwards.
- Fit the gaskets
(O)
onto the pins
(Fig.5)
- Place the machine on top of M-BOX making sure the four pins enter the holes in the bo om of the machine.
- Screws the
fi
xing screws into the bo om
(P)
of M-BOX and ghten well.
- Place the P-BOX module on a bench with the pins
(A)
poin ng upwards.
- Fit the gaskets
(O)
onto the pins
(Fig.5).
- Place the M-BOX module and machine on top of the P-BOX module making sure the four pins enter the
holes on the bo om of the M-BOX module.
(Fig.5)
- Hold the devices together and turn upside down.
- Screw the
fi
xing screws
(P)
into the bo om of P-BOX and ghten well.
- Fit the four rubber feet into the holes on the bo om of P-BOX
.