MAN465
Rev. 1.1
3
3
Introduction
This chapter covers the items that you will need to know before using the
VoltTab
,
including the names of all physical parts and their functions.
3.1
Overview
Thank you for your purchase of the M.C. Miller
VoltTab
Datalogger. To get the most of
the
VoltTab’s
functionality, please read through this manual and make sure to store it
somewhere where others who use the
VoltTab
can access and read it.
Removing and installing the tablet
If the tablet must be removed from the holder, loosen the thumb screw at the top of the
tablet and rotate the retaining tab 90 degrees clockwise. The tablet can be removed by
tipping it out from the top first.
To reinstall the tablet, place the tablet into the holder bottom first, tip it back into position,
rotate the retainer back 90 degrees counterclockwise and tighten the thumb screw.
Do NOT use excessive force when tightening the thumb screw.
Serial Number Location
The
VoltTab
serial number may be found in two places.
On the underside of the
VoltTab
enclosure – if the hand strap is in place, the serial
number may be partially covered.
Underneath the tablet, the serial number appears near the bottom of the holder.
Additionally, the
VoltTab
applications will also identify the unit’s serial number.
Camera location
The tablet offers both a front and rear camera.
At the top right there is a forward facing “selfie” camera and on the back side is a higher
resolution camera. These can be activated by the camera icon on the main screen, or
from a prompt within the Pipeline or Test Site applications.
