IU_
Mini
Tech_03
Page 7
Setup through a Dallas key
Lock setup can be performed in two different ways only when the lock is in pre-setup, through a
setup Dallas key or directly thorough a PC connected to the keypad.
To open a lock in pre-setup press
.
PRESS 1 TO OPEN
Power up the keypad. Press and hold
. LCD will display the
message:
SYSTEM SETUP
…..
Enter the setup Dallas key into the reader and connect the reader the
the keypad through the jack connector. LCD will display the message:
08:00 FRY
27/01/2006
Check displayed time and date, press
to confirm or
to update
the values and then
to confirm. LCD will display the message:
UPLOADING
..…
If the operation is successfully performed LCD will display the
message:
OPERATION DONE
Setup through a PC
Power up the keypad. Press and hold
. LCD will display the
message:
PC LINK
Press
. LCD will display the message:
PC LINK
…
Start the programming on the Setup software or press
to exit.
Dynamic codes
Power up the keypad. Press and hold
. LCD will display the
message:
DYNAMIC USER
X X X X
Enter the dynamic user PIN or the Dallas key. LCD will display the
message:
DYNAMIC CODE
X X X X X X X X X
Enter the dynamic code and press
.
Open within three seconds (green led).
If the lock is set to display closing code, LCD will display the
message:
CLOSING CODE
X X X
M-LOCKS BV - Vlijtstraat 40 - NL-7005 BN Doetinchem - T +31 (0)314 376 876
sales@m-locks.com - www.m-locks.com
Summary of Contents for Basic line Series
