DirectXion
M-LOCKS BV
Tel: +31 (0)314 376 876
Vlijtstraat 40
ver. 1.2 2010 10 28
Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem
1 of 2
www.m-locks.com
Technical manual
Mounting instructions
EM3510 DX
CHARACTERISTICS
The DirectXion lock can be mounted in all four mounting directions. Also, by flipping the lock,
all blocking directions can be achieved. The mounting dimensions are standard. The lock is
delivered with metric (M6) mounting screws. The PCB board in this lock is intended as an
OEM solution for customers who would like to control the lock via their own electronics. Once
voltage is supplied the lock will open for a 5 seconds. The lock can be opened. After 5
seconds the board will cut power to blocking element regardless if voltage is still supplied
from external system. To open the lock again after closure the voltage has to be dropped and
re-applied.
BOLTWORK REQUIREMENTS and MOUNTING INSTRUCTIONS
The maximum allowed cable/spindle-hole diameter is 12mm (if located under the lock body)
If the DirectXion lock is used in conjunction with another lock, the boltwork must be
constructed in a way that the DirectXion secures first.
Only use supplied screws to mount the lock. Tighten the screws securely so the lock body is
attached firmly to the mounting surface.
