4
www.m-locks.com
1
IMPORTANT INSTRUCTIONS
• Before using the lock, please read the instructions for use carefully.
• The instructions for use only relate to the lock itself and not to how to operate the safe.
• Ensure that you
only
program the lock while the
safe door is open
.
• After changing the code, always try the code several times with the safe door open.
•
Only after several positive function tests (opening / closing) the safe door may be closed.
• Each key entry is confirmed by an audible tone and visual signal. These signals are not referred to in
the description that follows.
• Acoustic signals are always accompanied by the same optical signals.
• You have a maximum of 10 seconds for each key entry. If you do not make an entry via the keypad
during this period of 10 seconds, the entry procedure will automatically abort. You must then start
again from the beginning.
• After entering a valid code, a double signal sounds. An invalid entry will trigger a long tone.
• After entering an invalid code the first attempt, wait 20 seconds before entering the code again.
• If the code is entered incorrectly on four consecutive occasions, the keypad and the lock will be
disabled for 5 minutes. During this period, the LED will flash every 10 seconds and you will hear a
long tone when attempting to make an entry. Entering an incorrect code on two further occasions
after the keypad has been re-enabled will trigger a new keypad lock-out period of 5 minutes. After
entering a valid code you have four new occasions to enter the code and open the lock.
• The lock works with a six digit code. In some cases it may be that the lock requires a 7-digit
code. For simplicity, it is mentioned only one operation with 6-digit code in this guide.
•
At the time of delivery
, the lock is set to the standard
Manager Code of 1 2 3 4 5 6.
Change this
code immediately to your own choice of Manager Code. Do not use personal or other simple data
which can easily be found out for your Manager Code
• If needed, the owner of the Manager Code can add up to 9 codes / users. This code must be imme-
diately changed by the user in a code of their own choice. Do not use personal or other simple data
for your user code.
•
User 9
always has an
override code.
This means that user 9 can always open immediately after
entering the first code, even if time delay has been activated.
If users are only allowed to open with time delay, user 9 should not be activated.
• Please keep the code always carefully and protect it against improper use by unauthorized persons.
• When typing in your code cover the keypad so no one near you can see your code.
• Depending on the used lock / keypad and the way the lock is installed, there are several ways to
open and to close a safe. By example with a lever or by turning the keypad. Please contact your safe
supplier for more information about your specific situation.
!
Our products fulfil the EN1300 requirements regarding resistance against electrostatic charge.
In fact it may happen that the electrostatic charge of a user exceeds the extreme value many
times.That’s why we are asking you to touch the metal surface of the safe for discharging before
operating the lock.
!
Caution! Don’t forget your code, otherwise the lock can not be used anymore!
