6
www.m-locks.com
5
FUNCTIONAL TEST
This functional test always with door open!
• Enter code. The lock emits a double signal for the correct code.
• Turn boltwork handle towards OPEN position.
The bolt rotates into the housing. Bolt must move freely.
• Turn handle towards LOCKED position.
The lock bolt must fully extend and secure.
• Make sure there is an air space on all sides of the lock bolt when the safe’s boltwork is fully thrown
into locked position.
Repeat the functional test several times before closing the safe door!
Check the keypad
If the lock does not react, follow the procedure below to check that your keypad is working.
Press and hold key
‘5’ until you hear a double tone. The LED will illuminate when performing the fol-
lowing actions:
5
Next, press all of the keys in one by one and one after the other.
1
2
3
4
5
6
7
8
9
0
If the key = OK
If the key = not OK , the test will be aborted.
If one or more keys do not operate properly, please contact your supplier.
Installation check
With door open, bring boltwork in LOCKED position:
- Deadbolt must only be loaded at the locking point.
- Avoid continuous pressure on the latch.
Only after several positive function tests (opening / closing) the safedoor can be closed!
