T9530
TechMaster
M-LOCKS BV
Tel: +31 (0)314 376 876
Vlijtstraat 40
ver. 1.0 2013 03 11
Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem
2
www.m-locks.com
KEYPAD DIMENSIONS AND GENERAL INFORMATION
With mounting plate add 3mm to thickness; with turnable plate add 9,7mm.
The diameter of the hole cable should be minimum 9mm,
maximum 12mm.
Prepare mounting and cable holes as indicated in the picture.
The hole must be deburred well to avoid damage to the cable.
Once the keypad has been mounted no more welding can be done on the safe.
ROTOBOLT LOCK
In the LOCKED position, there should be approximately 1mm clearance
between the lock bolt and the cavity in the blocking bar of the boltwork.
The lock bolt must move freely into the cavity.
Only use M-Locks supplied screws to mount the lock.
Tighten the screws securely so the lock body is attached firmly to the
mounting surface. Do not overtorque mounting screws. Maximum torque
3.5Nm.
Make sure there is an air space on all sides of the lock bolt when the safe’s boltwork is fully
thrown into locked position.
