MS-4K71-12TR USER GUIDE
09
support@m4sol.com | www.m4sol.com
Serial Communication Control
GUI Settings
• RS232 Communication Control
The camera is controlled via RS232. The RS232 serial port parameters are as follows:
Baud rate: 2400/4800/9600/38400;
Starting position: 1 bit
Data bit: 8 bits
Stop bit: 1 bit
Check digit: None
• RS485 Communication Control
Control camera via RS485, half duplex mode:
Baud rate: 2400/4800/9600/38400;
Starting position: 1 bit
Data bit: 8 bits
Stop bit: 1 bit
Check digit: None
After power on, the camera goes to the upper right limit and then back to the middle position. The zoom lens is pulled
to the farthest position, auto focus, and the aperture is adjusted to the default value. If the camera has preset 0 saved,
the camera will be set to position 0 after the initialization is completed. At this point, the user can use the serial port
command to control the camera.
• List of protocols (omitted)
The serial port of the camera follows the VISCA/Pelco-D/Pelco-P standard protocol. If secondary development is
required, the camera can be controlled according to the standard protocol.
MENU
Press [MENU] button to display the main menu on the normal screen, using
arrow button to move the cursor to the item to be set. Press the [HOME]
button to enter the corresponding sub-menu.
EXPOSURE
Move the main menu cursor to [EXPOSURE], and press [HOME] key enter the
exposure page, as shown in the following figure.
Mode: Exposure mode, optional items: Auto, Manual, SAE, AAE, Bright.
ExpCompMode: Exposure the compensation mode, optional items: On, Off
(Effective only in Auto mode).cExpComp: Exposure the compensation value,
optional items: -7 ~ 7 (Effective only in ExpCompMode item to On).
Backlight: Set the backlight compensation, optional items: On, Off (Effective
only in Auto mode). Bright: Intensity control, optional items: 0 ~ 17 (Effective
only in Bright mode). Gain Limit: Maximum gain limit, optional items: 0 ~
15 (Effective only in Auto, SAE, AAE, Bright mode). Anti-Flicker: Anti-flicker,
optional items: Off, 50Hz, 60Hz (Effective only in Auto, AAE, Bright mode).
Meter: Optional items: Average, Center, Smart, Top. Iris: Aperture value,
optional items: F1.8, F2.0, F2.4, F2.8, F3.4, F4.0, F4.8, F5.6, F6.8, F8.0, F9.6, F11.0,
Close (Effective only in Manual, AAE mode). Shutter: Optional items: 1/30,
1/60, 1/90, 1/100, 1/125, 1/180, 1/250, 1/350, 1/500, 1/725, 1/1000, 1/1500, 1/2000,
1/3000, 1/4000, 1/6000, 1/10000 (Effective only in Manual, SAE mode). Gain:
Optional items: 0 ~ 7 (Effective only in Manual mode). DRC: DRC strength,
optional items: 0 ~ 8.
