M-Spa Alpine, Owner'S Manual

13

Spa Storage 

After the spa is drained, unscrew the complete part of the air valve on the spa pool and the spa will be 

deflated. 

Make sure all water is drained from the Spa and control box.

This is essential to extend the life of the spa. 

We recommend the use of a wet/dry vacuum to blow out or suck up water from the Spa pipes and Pump 

lines. Remove the Filter Cartridge. It is recommended you store the spa in its original package in a warm 

dry place.

NOTE: 

Make sure all components are completely dry and clean before re-packing.

              Store safely in dry condition and out of sunlight.

Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures.

Freezing can severely damage the Spa. Improper winterization of your Spa may void your warrant

y

.

DISPOSAL 

1.The

marking 

 indicates that this product shall not be disposed with the 

general

 household 

waste. 

Please contact your local community about collection points or ask your dealer

.

2.This product contains valuable materials that can be recycled and contribute to a sustainable 

enviroment. 

3.For recover

y

, recycling and dismantling information for this product, please visit us at 

www

. the-mspa. com 

Drainage 

1.

 Turn of

f all the buttons on the control panel. 

2. Unscrew the valve on outside of the spa pool till it is detached from the drainage structure. 

3. Connect the black drainage hose on to the drainage structure. 

Make sure it is well connected and the other end of the drainage hose is connected to a ground drain. 

4.

 Pull and open the cover of the 

drainage

 structure inside of the spa pool, water will 

flow

 out from the 

drainage hose. 

5.

 T

ilt the spa until no water flow out to empty the spa completel

y

.

If you are going away for some weeks and nobody can follow up the water treatment 

program in your MSpa, please drain out the water before leaving and take out some 

air pressure.

Spa Pool Repair 

If

 the Spa is torn or punctured use the provided 

Repair

Patch.

 Dry the area to be 

repaired.

 apply the 

glue 

for PVC to PVC to the repair patch and then attach it onto the damaged area. Smooth the surface to 

remove any air bubbles.

 A

 secure unnoticeable repair can usually be made.  

Spa checklist before unpack the unit and re-use for the new season:

In order to have your MSpa runs smoothly and easily for another new season, make sure you do the follow:

1. Check if there is water in the air pipe. If any water is found, dry the air pipe before operating the spa tub.

2. Connect control panel correctly, turn on the spa tub, check if LED displays correctly and if the signal cable

is connected properly.

3. Press ON / OFF button on the control panel, open bubble function, check if it operates properly.

4. After doing the above steps, your MSpa should be ready for use. Enjoy it!

Any damage caused by improper storage or failure to do the checklist of reuse will void your warranty.