7
A. Site Requirements
WARNING:
The floor has to be capable of supporting the expected load.
WARNING:
An adequate drainage system has to be provided to deal with overflow water.
IMPORTANT:
Because
of
the
combined
weight
of
the
spa,
water
and
users,
it
is
extremely
important
that
the
base
where
the
spa
is
installed
is
smooth,
flat,
level
and
capable
of
uniformly
supporting
the
weight
for
the
entire
time
the
spa
is
installed.
If
the
spa
is
placed
on
a
surface
which
does
not
meet
these
require-
ments,
any
damage
caused
by
improper
support
will
void
the
warranty.
It
is
the
responsibility
of
the
spa
owner to ensure the integrity of the site at all times.
Be aware of special requirements if you install the spa indoors.
1.
The floor must be able to withstand the capacity of the spa.
2.
The floor should be a non-slip, level surface.
3. Proper drainage is essential for indoor spa installation.
4. When building a new room for the spa it is recommended that a floor drain be installed.
5.
Humidity
is
naturally
present
with
the
spa
installation,
determine
the
e
ffects
of
airborne
moisture
on
ex-
posed wood, paper, etc. in the proposed location.
6.
T
o
minimize
these
e
ffects
it
is
best
to
provide
plenty
of
ventilation
to
the
selected
area.
An
architect
can
help determine if more ventilation is needed.
NOTE: Do not install the spa on carpet or other material that can be damaged by moisture.
B. GFCI Test
WARNING:
RISK OF ELECTRIC SHOCK.
The GFCI plug must be tested before each use.
WARNING:
Insert the GFCI plug into a residual current device (GFCI) protected power receptacle only.
WARNING:
Before
inserting
the
plug
into
a
power
receptacle,
make
sure
the
current
rate
of
the
power
receptacle
and
the
fixed
wiring
are
suitable
for
the
spa.
Contact
a
qualified
electrician,
if
you
cannot
distin-
guish.
1. Insert the plug into the power receptacle. (1)
2.
The indicator light should turn red.
3.
Then press the “TEST” button.
The indicator light should disappear. (2)
WARNING:
Do not use if above test fails.
4. Press the “RESET” button again, the indicator light should turn red.
The spa is now ready for use. (3)
)
3
(
)
2
(
)
1
(
RESET
TEST
RESET
TEST
Summary of Contents for Alpine
Page 18: ......
