58
DL8 USERS
MANUAL EM-7691-B Rev.24
7.5 DISCRETE OUTPUT (DO)
7.5.1 ASSIGNING I/O SIGNALS
A maximum of 64-point discrete outputs (DO1 to DO64) can be used.
Assign discrete outputs of I/O modules and/or remote I/Os connected to the DL8, following the procedure below.
7.5.1.1 ASSIGNING I/O MODULE TO DO
(1) Click [Discrete output (DO)] button in “Input/Output” menu to open “Discrete output (DO)” list.
Double-click a row of the DO channel to configure to open the DO configuration dialog.
Input/Output
Discrete output (DO)
DO Configuration dialog
2.Double-click
1.Click
(2) Choose “I/O module” under “CH setting” to assign “Module address” and enter “CH No.” (Refer to 5. CONNECTING I/O
1. Select “I/O module”
2. Enter “Module address”
and “CH No.”
