PSP10
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-4890 P. 10 / 17
PC CONFIGURATOR SOFTWARE (MODEL: STCFG)
The PC configurator software helps the user to configure various parameters, execute Auto-setup, and to monitor operation
status of the actuator.
Download the STCFG from “Download” on the M-System’s web site https://www.m-system.co.jp
Prepare the PC and the USB Type-C cable separately.
For details, refer to STCFG users manual.
PROGRAMMING UNIT (MODEL: PU-2x)
The Programming Unit (model: PU-2x) helps the user to configure various parameters, execute Auto-setup, and to monitor
operation status of the actuator.
Turn SW1-8 ON to enable configuration and Auto-setup execution on PU-2x.
Monitoring can be conducted regardless of whether SW1-8 is ON or OFF.
■
DISPLAY OF PU-2x
G
ITEM No.
I
（
）
D
Response
Indication of set value
LCD display
■
HOW TO USE PU-2x
1) Turn SW1-8 ON to enable configuration or Auto-setup execution.
2) Connect the connection cable of PU-2x to the modular jack on the actuator unit.
The display of PU-2x comes on by power supplied to the actuator unit.
3) To display a target item, press [ITEM], then [N], [N] ([N] represents numerical number 0 to 9).
Alternatively, use [UP] or [DOWN] button to shift to the next item from the currently displayed item.
4) To change the setting value of the target item being displayed, press [DATA], enter a value, and press [ENTER].
Enter an integer or a value with two decimal place depending on the item.
When setting a tag, alphabetic characters can be used.
5) Confirm that ‘OK’ is displayed.
If the entered value is invalid or SW1-8 is OFF, ‘DATA-ERR’ will be displayed.
6) When configuration or Auto-setup is completed, remove the connect cable of PU-2x from the actuator unit, and turn SW1-
8 OFF.
■
RESPONSE MESSAGES
OK
:
OK
NON-ITEM : Item is not applicable
DATA-ERR : Value is invalid or out of range
■
PARAMETER ITEM LIST
Refer to “PARAMETER ITEMS COMMON TO MODBUS, CONFIGURATOR SOFTWARE AND PU-2x” for the parameter
item list.
