R7F4DC-DC16A-H
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-7767-N P. 5 / 7
MOUNTING INSTRUCTIONS
■
DIN RAIL MOUNTING (PARALLEL)
• Mounting
A) Set the upper hook at the rear side of the unit on the DIN
rail.
B) Push in the lower.
A
B
• Dismounting
A) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
B) Pull the lower of the unit.
C) Remove the upper hook of the unit from the DIN rail.
A
C
B
■
DIN RAIL MOUNTING (RIGHT ANGLE)
• Mounting
A) Insert the longer DIN rail mounter slider until it clicks
twice, as shown below.
A
B) Set the upper hook at the rear side of the unit on the DIN
rail.
C) Push in the lower.
B
C
Note: leave at least 10 mm (.39 in.) at the both side of the unit.
• Dismounting
A) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
B) Pull the lower of the unit.
C) Remove the upper hook of the unit from the DIN rail.
C
A
B
■
SURFACE MOUNTING
A) Insert the two DIN rail mounter sliders until it clicks
once, as shown below.
A
A
B) Mount the unit with M4 screws referring the External
Dimensions. (Torque: 1.4 N∙m)
