W2CA / W2CE
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-5537 Rev.8 P. 2 / 3
COMPONENT IDENTIFICATION
Model
SPAN
ZERO
SPAN
ZERO
Body
Connector
Insulated Input Cable
Fixing Plate for
Cable Fitting
Cable Fitting
CT Protector
Base Socket
Fixing Screw
Connection
Diagram
Specifications
*
Provided only for dual output.
Zero Adj.
Span Adj.
Zero Adj.
Span Adj.
Output 1
Output 2
*
INSTALLATION
Loosen the fixing screw at the front of the unit in order to
separate the body from the base socket.
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
■
DIN RAIL MOUNTING
Set the base socket so that
its DIN rail adaptor is at
the bottom. Position the
upper hook at the rear side
of base socket on the DIN
rail and push in the lower.
When removing the socket,
push down the DIN rail
adaptor utilizing a minus
screwdriver and pull.
■
WALL MOUNTING
Refer to “EXTERNAL DIMENSIONS.”
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the connection diagram on the side of the unit.
Attach the CT Protector together with input wiring to the input screw terminals.
■
EXTERNAL DIMENSIONS unit: mm (inch)
DIN RAIL
35mm wide
approx. 200 (7.9) (total of both sides)
6 (.23)
CT PROTECTOR (model: CTM2)
28 (1.10)
4
8 7
10
22 (.87)
59 (2.32)
11–M3
SCREW
72 (2.83)
29.5 (1.16)
2–4.2x5
(.17x.20)
MTG HOLE
6 (.24) deep
11
5
6
1
2
3
9
21.5 (.87)
88.5 (3.48
)
84 (3.31)
10 (.39)
[4 (.16)]
53 (2.09)
114 (4.49)
• When mounting, no extra space is needed between units.
■
CONNECTION DIAGRAM
LOAD
SOURCE
k
l
CT
L
K
CT PROTECTOR
model: CTM2
U(+)
V(–)
POWER
10
11
+
–
OUTPUT 1
7
8
+
–
3
6
OUTPUT 2
1
2
The section enclosed by broken line is only with 2nd output option.
