20
E8 Operating Manual
Programming For Horn In Neutral Operation
-
Reset Feature
25 (5 Clanks)
Reset Feature 25 allows you to operate the Horn while the engine is in the
Neutral state. When ON, pressing the Horn/Whistle button while in
Neutral, with 10V AC or less on the track, will cause the Horn recording to
sound. To use, cycle to Reset 25 and press the Horn/Whistle button. The
engine will play a series of bells. This indicates the current setting. Each
time the Horn/Whistle button is pressed, Proto-Sound® will cycle to the
next available setting and
provide the appropriate bell
indicator. The settings for
Reset 25 are 1 Bell = OFF, 2
Bells = ON. When the
desired setting is reached, lock
the changes by interrupting
the throttle and cycling the
engine into forward.
Programming For Proto-Coupler® Operation-
Reset Feature 10
(2 Clanks)
Reset Feature 10 allows you to turn the operation of the ProtoCoupler on or
off. When OFF, the coupler will not arm or fire from Neutral. To use,
cycle to Reset Feature 10 and press the Horn/Whistle button. The engine
will play a series of bells. This indicates the current setting. Each time the
Horn/Whistle button is pressed, Proto-Sound® will cycle to the next
available setting and provide the appropriate bell indicator. The settings for
Reset Feature 10 are 1 Bell
= ON, 2 Bells = OFF.
When the desired setting is
reached, lock the changes
by interrupting the throttle
and cycling the engine into
forward.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
25 Times
Listen For 5 Clank
And 0 Clink Sounds
Push The Horn/Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Horn Setting
H
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
10 Times
Listen For 2 Clank
And 0 Clink Sounds
Push The Horn/Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Coupler Setting
H