Premier J1e Hudson Steam Locomotive
5
Figure 6: 3-Rail Proto-Coupler
Tender Couplers
Figure 5: Pre-drilled Kadee® Coupler mounting holes
All 2-rail locomotive models do not
come with a rear coupler since
many 2-rail enthusiasts may utilize
different coupler types on their 2-
rail locomotives and cars. Each
tender does not have pre-drilled
holes for use when installing a
Kadee® scale coupler as seen in
Figure 5. Follow the individual
coupler installation instructions
when installing another
manufacturer’s coupler system.
Proto-Coupler Installation
Owners of 2-rail models who
intend to run this locomotive on a
3-rail layout may wish to use the
M.T.H. Proto-Coupler so that may
enjoy the remote uncoupling
anywhere on the layout.
A Proto-Coupler and the necessary
mounting hardware are included in
the packaging with each 2-rail
locomotive. The wire harness in the
tender is prewired with a plug-in
connection for the Proto-Coupler.
To install the Proto-Coupler on a 2-
rail tender, follow the step by step
instruction listed below.
- First remove the Kadee Coupler
Mounting Plate from the bottom of
the tender chassis.
- Next remove the shell from the
tender by removing the 6 body
screws and then unplug
The wire harness between the shell
and the chassis.
- Remove the 3 screws that secure
the speaker. The speaker can be
unplugged and set
aside until it is
needed for reassembly.