Troubleshooting
Although the horn and bell model has been designed and engineered for ease of
use, you may have some questions during initial operation. The following table
should answer most questions. If your problem cannot be resolved with this table,
contact M.T.H. for assistance
(Order online: www.mth-railking.com, e-mail:
parts@mth-railking.com,Fax: 410-423-0009, Phone: 410-381-2500, Mail: 7020
Columbia Gateway Drive, Columbia MD 21046-1532, ).
Starting Up
Horn
Bell
Remedy
Remedy
Remedy
When I first turn the power on, the
engine will not begin to run.
The engine will not start after I press
the Direction button.
I can't get the horn to blow when I
press the horn button.
I can't get the bell to ring when I press
the bell button.
You may be pressing the button too quickly. Try pressing
the whistle button more slowly, taking approximately one
full second to fully depress the button.
You may be pressing the button too quickly. Try pressing
the bell button more slowly, taking approximately one full
second to fully depress the button.
This is normal behavior. To prevent accidental high-speed
start-ups, the model is programmed to start up in neutral
anytime track power has been turned off for several seconds.
You may not be sending enough power to the track to power
the engine. Press the throttle up for a few more seconds to
increase track power.
Volume
Remedy
No sound horn or bell sounds.
Volume is set too low, adjust master volume control on the
bottom of the chassis clockwise to increase the volume or
check connector to speaker.
RKS SD70ACE with Horn & Bell
10
