ME401-2
M-Tec ME401-2, Technical Manual v.1.3a, September 2012
Page 18
SMS commands for output control
Function
Send SMS
Return SMS
Description
Time controlled
activation of the
output
MT OUT1=1,30
MTC ACK (SERIAL No.)
OUT1 TIMER=1
MINUTES 30
SECONDS
With this command the output will be
activated for a number of defined minutes. In
the example 1 minute and 30 seconds was
used. The output is activated immediately
after the acknowledge SMS has been send
out and it is deactivated automatically when
the timer runs out.
NOTE:
It is possible to break the output before
the timer runs out by using the “OFF”
command.
Permanent
activation of the
output
MT OUT1=ON
MTC ACK (SERIAL No.)
OUT1 ON
With this command the output is activated
permanently. The output can be de-activated
again using the “OFF” command.
Deactivation of
the output
MT OUT1=OFF
MTC ACK (SERIAL No.)
OUT1 OFF
With this command the output is deactivated.
The command will work for any activation
mode either “time controlled” or “permanent”.
NOTE:
For the “Send SMS” it is of no importance if small or capital letters are used in
the command string, or a mixture hereof.
Safety precautions
The use of the digital output is restricted to signals/systems/components related
to comfort applications in the vehicles.
Under no circumstances must it be used for purposes, which can influence the
safety of the vehicle when driving.
M-Tec holds no liability for any damages occurred to persons, vehicles, moving
machines, construction machines etc. caused by wrong installation and/or faulty
use of the digital output.
