TOOLS REQUIRED: Screwdriver, 11/32 wrench, socket or spintite, a 7/16" and 1/2" wrench
or socket, tape measure. For best results please review instructions before assembly.
1. Assemble the boom (SEE DIMENSION SHEET).
2. Install the boom to mast plate with two 2” U-bolts and cradles, placing it at about 53” from
the rear of the boom.
3. Layout the elements using dimension sheet and Install using 6-32 X 1” screws to hold
elements in place.
Note:
Leave Driven Element Rod screw lose until shorting bars are
positioned (SEE DRIVEN ELEMENT DETAIL PAGE).
4. Install Driven Element Assembly & Shorting Bars.
(SEE DRIVEN ELEMENT DETAIL PAGE & DIMENSION SHEET).
5. Install the two gold SEAL NUTS on the Driven Element Balun connectors with the black
neoprene face out. Locate the 1/2 wavelength balun cable assembly and form into a large "U"
shaped loop. Tighten up the 7/16" balun connector nuts gently with a 7/16" end wrench first.
Then run the seal nuts up against the face of the connectors and tighten about 1/2 turn more
with a 1/2" end wrench. Tuck Balun into rear of boom and secure.
6. Install the feed line. Route feed line on the underside of boom towards Boom to Mast Plate
and secure with nylon ties.
This completes the assembly.
M
2
ANTENNA SYSTEMS, INC.
4402 N. Selland Ave.
Fresno, CA 93722
(559) 432-8873 FAX: 432-3059
www.m2inc.com
Email:
sales@m2inc.com
235-11 ASSEMBLY MANUAL
