MSR-B2MWA, MSR-B2MWA-DONGLE Hardware Manual
M
2
I Corporation
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do, 14055，Republic of Korea
4 / 17
Chapter 1. Safety Precautions
Before using the product
To use the product safely and effectively, please read the contents of this manual thoroughly before use.
Please keep to the safety precaution, for it is to prevent accidents and potential danger from occurring.
Safety precaution is classified into ‘Warning’ and ‘Caution’ and their meanings are as follows
.
Also the
indicated illustrations on the product and in the manual have the following meanings.
Violating the instruction may result in serious personal injury or death.
Violating the instruction may result in slight personal injury or product damage.
Be cautious, for danger may be present.
Be cautious, for there is a possibility of an electric shock.
General Precautions
Do not press the screen with a hard or sharp object (awl, screwdriver, pen) with too strong a force. It may
cause malfunction of touch due to damage of the front sheet.
Do not use or store in an environment with high vibration.
Do not allow foreign objects such as water, liquids, or metal powders to enter the product. This may cause
breakage or electric shock.
Do not allow foreign objects such as water, liquids, or metal powders to enter into the front(screen)
protective sheet. The screen may be invisible or may cause a malfunction of the touch.
Use the radio or mobile phone at least 30cm away from the main unit.
Two or fewer bright spots may appear on the display, and certain areas may appear brighter, but this is not
a defect in display characteristics.
Do not store or operate in direct sunlight. Direct sunlight can change the properties of the display.
Do not touch the adapter or power cord with wet hands. There is a risk of electric shock.
Do not charge or use the battery in explosive environments with flammable liquids, gases, or dust.
When storing the product for a long time without using the product, store it in a dry environment without
direct sunlight.
Record/store your data separately. When the product is repaired, the main contents of the device may be
deleted.
Installation Precautions
Do not install the location which exceeds allowed temperature. Product can be damaged or shorten the life.
Especially Install environment as below should be avoided.
Do not Install product to the place which the ambient temperature is out of limits, from 10℃ to 45℃ or on the surface
of control board which high pressure equipment is installed.
Do not install to the place where strong shock or vibration continuously have impacted on product.
When leaving for a long time without using the product, charge it and store it at room temperature.
Indoor use.
Altitude up to 2000m.
Summary of Contents for UDJET MSR-B2MWA
Page 1: ......
