RTCU LX4 pro Technical Manual V1.00
Advanced Industrial M2M/IoT Gateway
Logic IO ApS.
Ph: (+45) 7625 0210
Holmboes Allé 14
Fax: (+45) 7625 0211
8700 Horsens
Page 27 of 39
Denmark
Switches
DIP-switch
The RTCU LX4 pro unit contains four dip-switches, and three of them are available for the application
to use (the
fourth dip-switch is reserved for future use
).
The dip-switches are located on the top side of the unit for easy user access (see the graphical
overview).
System switch (RST)
The RTCU LX4 pro device contains a combined reset/diagnostic switch. This switch is accessible from
the front of the unit (see the graphical overview). It is necessary to use a small thin object with a
diameter of approx. 2 mm, for example, a straightened-out paper clip for this purpose.
By activating the switch shortly, the RTCU device will perform a full reset.
If the reset switch is held down for approx. 3 seconds
1
, the device will instead enter recovery mode
2
,
and the application will not be started. The system will automatically turn on the cellular engine in
recovery mode to connect to the network and RTCU Communication Hub (if configured).
Pressing reset will also activate the device when in power-down mode. If external power is removed
and the backup battery is disabled, the reset switch can still be used to boot into recovery mode, as
long as there is enough power left on the battery.
1 System LED S2 will flash green three times when this state is entered.
2 System LED S1 will indicates this state by fast blinking green or yellow.
