1.
Starting the Router
1.1 Cable connection
1. Mount a 2G/3G or two LTE SMA antenna –
according to the module type - to one of the
Antenna titled SMA-M interfaces (in case of LTE
module all the two antenna must be mounted).
2. If there is a WiFi module presented, then connect
a WiFi antenna to the WiFi titled antenna
connector.
3. Insert an activated data SIM card to the SIM
holder, placed the chip-side up and the cutted edge
towards to inside and push until it sleeves.
4. Connect UTP cable to the RJ45 port
(Ethernet titled), the other side of the cable must
be plugged to the PC or a current network device.
5. The DHCP service is turned off for the
router Ethernet interface, by default. Therefore,
you
have
to
configure
an
IP
address for you PC, manually.
1.2
First starting of the router
1.
Plug the 12V DC power adapter chord to the POWER interface, then plug the adapter to
the 230V electrical network.
2.
The router has a pre-installed system (contains uploaded firmware and system software).
By plugging the power adapter to the 230V AC socket, the router begins to work, whereas its
LED signals are showing the current activity during the operation.
Add for. e.g. the 192.168.127.10 IP address to your computer’s Ethernet interface for connecting
to the router.
(If you have the WiFi onboard version of the router, then you can configure your router on WiFi
(DHCP activated).
