General Specifications
•
Built-in GPRS communicator
•
Remote control via Smartphone
•
2 Partitions
•
8 Wired zones
•
32 Wireless zones
•
Supports up to 16 keyfobs with rolling code
•
1 bell output and 1 programmable output (open collector 500mA)
•
Short circuit protection of the AUX
Wiring the RControl Alarm panel
Wiring the power supply module
•
The L and N terminals should be connected to the powerline (220V)
•
The -V output should be connected to the (-) of the alarm panel
•
The +V output should be connected to the (+) of the alarm panel
Wiring a siren
The siren should be connected to AUX(+) and BELL(-). The programmable output for the siren BELL(-) is
an open collector 500mA.
SMARTEnroll
–
self-learning zones
RControl Alarm panel supports SMARTEnroll feature
–
preconfigured settings and self-learning zones,
which in most cases eliminate the need of initial programming of the alarm panel. This simplifies the
installation process in the most commonly used scenario, when only instant zones with no entry/exit
times are needed.
By default, all wired zones of the alarm panel are initially
set to “S
MART
Enroll”
type. When a new wired
detector is connected to any zone (when the zone is closed), the zone is registered automatically and
the panel starts monitoring that zone. Zones Z1-Z7 are self-registered as instant zones and zone Z8
–
as a
tamper zone (24h Tamper). When a new zone is being self-registered, the panel reports an event
“Added module, Zone N” with ContactID E
-531.
By default, when a zone is not used it should not be short circuited to the AUX(-). However, if a zone is
already self-registered and will be no longer used, it should be short circuited to the AUX(-) or it should
be disabled, as described in section “Configuring the zones of
RControl Alarm panel
”.
When you pair a wireless zone it also automatically registers as instant zone.
If the default configurations are not suitable, the zones can be configured from the RControl Admin
Portal, as
described in the section “Configuring the zones of
RControl Alarm panel
”.
