Disabling a wireless keyfob
If a paired keyfob is lost, you can disable it from the RControl Admin Portal. To do that you have to
navigate to RControl Alarm menu, section Keyfobs and set “Enable” property to NO for the keyfob that
you want to disable.
Deleting all wireless keyfobs
To delete all the paired keyfobs, hold the white button of the RF receiver for around 10 seconds. After
the LED indicator goes OFF and you hear a one-time confirmation sound from the siren, ALL the paired
keyfobs will be deleted from the receiver memory.
NOTE:
This procedure will delete
all paired
keyfobs! To pair them again, you should repeat the pairing
procedure for each keyfob.
Labelling the keyfobs
Each keyfob reports with different user number in the range between 101-116. When pairing the
keyfobs they automatically receive labels “
Keyfob 101
–
Keyfob 116
”
. These labels appears in the
mobile application when arming/disarming with keyfob.
You can change the keyfob labelling anytime from the RControl Admin Portal by navigating to RControl
Alarm menu, section Keyfobs. The End User can also change the labeling from the mobile application by
navigating to Settings menu, section Labels if the End User is a Master User.
Wired and wireless detectors
Adding wired detectors
Detectors with normally closed relay contacts are used. The zones of the alarm panel are digital inputs
thus no EOL (end-of-line) resistors should be used. The detectors should be connected to the AUX(-) and
to a zone of the alarm panel. The tamper can be connected to a zone configured as 24h tamper.
Pairing a wireless detector
The RControl Alarm panel supports up to 32 wireless detectors.
NOTE: You cannot pair detectors while the system is armed. Before entering into learning mode first
make sure that the panel is DISARMED!
