MARLEY MKII
HIGH PERFORMANCE HEADPHONES AMPLIFIER
REVISION P
R
A – JUNE 2019
Copyright © 2019, M2Tech Srl
20
M2Tech
www.m2tech.biz
WARNING: pay attention to the volume setting when the muting is active: if volume
is raised too much, once the muting is reset the listening level could be too high so
as to damage the headphones or even the listener’s ears. It is always wiser to limit
volume when in mute mode and even when turning on and off the
MARLEY MKII
.
7.3. Source Selection
The
Marley MkII
is provided with various inputs, therefore it is possible to connect different
sources and select which one to listen to.
To select a source, press the encoder shortly. The name of the current source will start
flashing on the display. Rotate the encoder until the desired source is displayed. Then,
press the encoder again to confirm: the new source will be selected.
Should the user change his/her mind and keep the current source, it is sufficient to push
the button to the right of the front panel (item 7, Fig. 1) or avoid doing anything else: After
a few seconds the
Marley MkII
will automatically return in its “idle” status without changing
the source setting.
7.4. Menu Navigation
The
Marley MkII
allows for configuring various parameters, some of which (the ones less
frequently changed) are grouped in a menu which can be navigated by both the front
panel’s controls and the dedicated keys on the remote control.
To access the menu, keep the encoder pressed for at least two seconds or push the
“MENU” key on the remote control or access the configuration page in the app.
It is possible to scroll the various menu items with successive short pushes of the encoder
or with the “arrow up” and “arrow down” keys on the remote control.
Once the desired menu item is displayed, it is possible to choose the desired value
amongst the allowed values rotating the encoder or using the “arrow left” and “arrow right”
keys on the remote control.
The new value can therefore be confirmed with a new short push of the encoder or by
pushing the “OK” key on the remote control.
If, at this point, the user changes his/her mind and wants to keep the current value, it’s
possible to exit the menu by pressing the front panel’s left button or by pushing the “ESC”
key on the remote control.
Following is a description of all menu items.
