M2Tech
www.m2tech.biz
MITCHELL
STEREO ANALOG ELECTRONIC CROSSOVER
REVISION P
RB
– DECEMBER 2020
Copyright © 2020, M2Tech Srl
15
5. Cleaning the Unit
The
MITCHELL
should be cleaned with a soft, slightly damp cloth. Do not use alcohol or any
other types of cleaning fluids as they could damage the unit.
Avoid fluids from dropping or leaking inside the unit. Fluids of any type poured into the unit
will void your warranty.
Be careful not to scratch the Plexiglass front screen.
6. Trigger
The
MITCHELL
accepts trigger signals, 5V
DC
to 15V
DC
. A trigger signal can be used to
automatically activate the
MITCHELL
by a preamplifier, so that all the system is powered on
and off by the preamplifier’s remote control. The trigger input has priority on the front panel
button: the
MITCHELL
cannot be turned off by the front panel button as long as the trigger
voltage is applied to the trigger input. As well, the
MITCHELL
will power off when the trigger
voltage is removed. The trigger input also has priority over the remote control: if the
remote control sensing is enabled and an on/off command is sent by the remote control
while the trigger voltage is applied to the
MITCHELL
, the unit will not turn off.
