M2Tech
www.m2tech.biz
MITCHELL
STEREO ANALOG ELECTRONIC CROSSOVER
REVISION P
RB
– DECEMBER 2020
Copyright © 2020, M2Tech Srl
7
1. Unpacking and Placing the Unit
Lay the box on a table and open it with a cutter or a knife, paying attention not to damage
the internal box. Extract the internal box and open it. The following items are included in a
cardboard tray:
one
MITCHELL
;
one 15V wall adaptor;
one USB cable;
two XLR adaptor cables.
Should one or more item be missing, please contact your retail dealer.
Remove the
MITCHELL
from the cardboard tray enclosure and place it onto a stable base,
far from heat sources. Avoid full sunlight on the unit. Allow for ample room around the unit
for venting.
The
MITCHELL
is an audio device which operates at line level, therefore, only a reduced
heat production is expected. Nevertheless, its circuitry operates at high bias for improved
performance. Therefore, an adequate air flow is recommended.
Avoid smoke, moisture, dirt and liquids from reaching the unit. Please note that any signs
of abuse will void warranty coverage.
Do not place the unit on thick carpets or inside a box or piece of furniture, not even close
to curtains.
