M2Tech
www.m2tech.biz
MITCHELL
STEREO ANALOG ELECTRONIC CROSSOVER
REVISION P
RB
– DECEMBER 2020
Copyright © 2020, M2Tech Srl
9
2. Front Panel
2 3
4
1
5
Figure 1
1) IR sensor.
Receive commands from Rockstars remote controls. It’s useful to let the
MITCHELL
enter/exit standby together with other Rockstars units in the system. This feature
must be enabled by the configuration app at set-up.
2) ON/OFF button.
Allows to turn the
MITCHELL
on and off. Also, when the
Mitchell
is in
standby, pressing this button will activate it.
3) Standby LED (blue).
It’s on when the
MITCHELL
is in standby.
4) Active LED (white).
It’s on when the
MITCHELL
is active.
NOTE: during firmware update, either LEDS can be on, depending on the condition
at update beginning.
5) Micro-USB port.
Used for configuration and firmware update. Use the stock cable to
connect to a computer.
