![background image](http://html1.mh-extra.com/html/m3d/pro/pro_replacement-manual_3130391011.webp)
Step 8.
If you are running into any grinding noises please continue with this step.
Once the extruder is off you should be able to see the X gear and encoder wheel
inside the holes where the X rods are inserted. A encoder wheel rubbing up against
the encoder could be causing your noise issue. Please provide a picture like the one
below.
If you cannot get a good shot of the encoder wheel and encode together then please
continue with the next step.
Step.9
In this step we will disassemble the extruder core slightly to get a better photo of the
encoder wheel and encoder. Pinch the bottom of the front cover to remove it.
1.