eMail: info@malighting.de . Tel.: +49 9 31 49 79 40 . User's Manual MA Optoisolator PCB
11111
Art.No. 130420
Art.No. 130420
Art.No. 130420
Art.No. 130420
Art.No. 130420
The MA Optoisolator PCB provides optical galvanic separation and enforcement of DMX 512 (1990)
input and output signal. Current boost is also provided allowing for longer cable runs.
In addition, the isolation also provides ground loop and shock hazard protection.
MA Optoisolator PCB
FEATURES:
DMX IN:
Overvoltage protected DMX input
OUTPUTS:
Optically isolated amplified output
The DMX output is overvoltage protected
ERROR HANDLING:
Check fuse if the Optoisolator PCB fails to function.
ERRORS may be caused by:
Contact problems with cables and connectors
Short circuit and/or wrong pinlayout
Lack of cable shield or missing data input
Incorrect cable or extremely cable length
>
NOTE:
All DMX512 inputs and outputs must be shielded and the shielding must be con
nected to the ground of the corresponding plug.
The PCB has to be installed into a metal case and connected by a specialist follow
ing the valid electrical and EMC regulations.
This PCB is not a complete appliance and therefore a CE mark is not needed.
TECHNICAL DATA:
Mains supply:
230 VAC / 50 Hz or 110 VAC / 60 Hz (factory setting)
Signal input/output:
Wago sockets
PCB dimensions (mm)
44 x 115
Made in Germany
