Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 29 -
0: SD card is not inserted.
1: SD card is detected.
2: SD card is not detected well.
* In case of 2, Please check if the SD card is
completely inserted.
4.7 Machinery Info
To look over the date of production, serial number and firmware version on the
machine.
1.
Use the
“F1” and “F2” key
to highlight
“Machinery Info” under the main menu,
and press “
” for confirming selection.
2.
All the versions information of firmware
and detection is showed on the display.
*Note: If currency list isn’t shown completely on
the display, please press “Down” key to move to
next page.
3.
Press “F2” to see the completed
currency version.
4.
Press “
” to go back to upper layer.
4.8
Setup Device Parameters
To change the machine setting parameters.
1.
Use the “F1” and “F2” key to highlight
the option and press the “
” to toggle
between options.
2.
After modifying the setting, highlight
SAVE and press “
” to confirm setting.
Once the display shows “SAVE OK”, the
modification is saved.
3.
To go back to factory default setting,
highlight the initialization and press “
”.
