21
Hakki Pilke 38 Easy
Original
Version 6
3.
Sensor A is used to determine
the point at which the splitting
cylinder will stop during the
reversal motion. If necessary, the
position of the sensor can be
changed with tightening nut B.
4.
Sensor C is used to determine the
point at which the splitting
cylinder changes direction during
the splitting motion, in other
words, how close to the splitting
beam will the splitting blade go.
If necessary, the position of the
sensor can be changed by
tightening nut D.
Note! The covers and guards must be
reattached after maintenance.
Figure 24.
Figure 25.
4.5.
Using the output conveyor
The output conveyor can be controlled horizontally and vertically. The safety zone for the output conveyor is
10 metres. When operating the machine, the maximum permitted angle of the output conveyor is 40°. The
running speed of the output conveyor can be freely adjusted with the adjustment screw G (in Figure 10). If
the conveyor is jammed for any reason, its running speed must be set to zero and the splitter must be shut
down before removing the cause. There must be at least 50 cm between the end of the output conveyor and
the pile of processed firewood.
The tension (and alignment) of the output conveyor’s belt is adjusted with nuts A (2 pcs) by loosening the
adjustment nut on the side to which you wish the belt to run.
