25
Hakki Pilke 38 Easy
Original
Version 6
6.
Use the adjustment screws E (4
pcs) to lift the motor bed F high
enough to enable you to
remove the V-belts D (3 pcs).
7.
Remove the old V-belts and
install the new ones.
8.
Lower the motor bed with the
adjustment screws E in order to
tighten the V-belts. Note! Make
sure that the belt pulleys are
aligned.
If
necessary,
the
location of the motor can also
be adjusted horizontally.
The V-belts are at the correct
tension
when
they
give
approximately 20 mm when
the belt is pressed down at a
moderate force.
5.3.
Changing the oil of
the splitter
Change the hydraulic oil of the splitter
as follows:
1.
Shut down the splitter and
disconnect it from its power
sources.
2.
Remove the rear cover of the
machine in accordance with the
instructions in steps 1–5 in
Section 5.3.
3.
Open the filler cap A of the
hydraulic oil tank (this will allow
the oil to drain more easily).
4.
Open the drain plug B and drain
the oil into a suitable container.
5.
Open the cover of the hydraulic
filter C and replace the filter.
6.
Tighten the plug B firmly, and fill
the tank with fresh oil (approx.
55 litres).
7.
Finally, ensure that the oil level
settles between the maximum
(E) and minimum (D) limits
indicated on the dipstick.
Figure 32.
Figure 33. Figure 34.
Figure 35. Figure 36.
