26
Hakki Pilke 38 Easy
Original
Version 6
5.4.
Changing the oil of the angle transmission
1.
Remove the rear cover of the machine in
accordance with the instructions in steps 1–
5 in Section 5.3.
2.
Open the filler cap A (this will allow the oil
to drain more easily) and the drain cap C
and the drain the oil into a suitable
container.
3.
Close the drain cap C and open the
inspection cap B.
4.
Add appropriate oil into the angle
transmission through filling hole A, until the
oil surface is level with the level inspection
hole B.
5.
Finally also close caps A and B, and re-install
the rear cover of the machine in reverse
order of steps 1 to 5 in Section 5.3.
Figure 37.
5.5.
Conveyor maintenance
5.5.1.
Replacing and tightening the belt of the input conveyor
Replace the belt of the input conveyor
as follows:
1.
Shut down the splitter and
disconnect it from its power
sources.
2.
Raise and lock the input
conveyor into the transport
position. (See Section 3.1)
3.
Move the belt joint to a
suitable height.
4.
Disconnect the joint by using,
for example, pliers to pull out
the pin (A) holding the joint
together.
5.
Remove the old belt.
6.
Slide the new belt under the
table from the side of the
input conveyor's drive roller
until you can pull the belt out
from the other end (C).
7.
Lead the rest of the belt under
the wood press, around the
rear roller and, finally, behind
the conveyor.
Figure 38.
Figure 39. Figure 40.
