28
Hakki Pilke 38 Easy
Original
Version 6
5.5.3.
Replacing the plates of the output conveyor
The plates of the output conveyor can be replaced by disconnecting the bolt joints (3 x M8) fastening the
plates and replacing the plates with new ones. It is recommended to move the belt into a position that puts
the plate to be replaced above the conveyor. Shut down the machine and disconnect it from the power
source for the duration of the procedure.
6
Lubrication
All of the log splitter's lubrication points, which require Vaseline, have been labelled. The lubrication must be
performed every 10 hours. There are nine lubrication points, presented in the figures below.
1.
Grease nipples of the height adjustment device of the splitting blade (2 pcs) in Figure 42.
2.
Grease nipple of the output conveyor reversal link (1 pc) in Figure 43.
3.
Hinged nipples of the guard (2 pcs) in Figures 44.
4.
Cylinder nipples of the cutting unit (2 pcs) in Figures 45 and 47.
5.
Grease nipples of the joint of the cutting unit (2 pcs) in Figure 46.
6.
Grease nipple of the log length device in Figure 48.
Figure 42.
Figure 44.
Figure 43.
Figure 45.
