t +31 88 500 2800
10
260123
7. MONTAGE
7.1 INBOUW MONTAGE (HOUT)
1. Cutting the mortice
Referring to the product dimension drawings, a mortice is cut into the door frame to fit
the lock and a mortice is cut into the door leaf to fit the strike. Wooden doors and frames
require full mortices with space made behind the lock body to accommodate the wire
connections.
It is crucial to ensure that the mortices in the door leaf and frame are aligned vertically
and horizontally when the door is closed as this aligns the bolt pin to the strike opening
and also the strike magnet to the locks internal door position sensor.
Ensure that the final gap between the lock face plate and strike plate once it is installed
will be no more than 6mm.
2. Wiring the lock
A hole needs to be drilled in the back of the mortice to bring the wires out and a
connection can be made to the supplied wire loom which in turn plugs into the lock.
Refer to the Wiring section of this document for detailed instructions on wiring.
3. Setting the operating mode
Ensure the operating mode switch is positioned to the required state, Fail Safe or Fail
Secure.
Refer to the Operating Mode section of this document for detailed instructions on wiring.
4. Fitting the lock and strike plate
The lock can be slid back into the door frame mortice, ensuring that the wiring integrity
is maintained, and then secured in place with the supplied 10G self-tapping screws.
Please ensure the lock is the correct orientation as to pull the door into the door jamb.
The strike is then placed into the door leaf mortice and the remaining 10G self-tapping
screws are used to secure it in place. Ensure the strike is oriented so that the bolt hole
aligns with the lock bolt.
ELEKTRISCHE SLOTEN