info@maaslandgroep.nl
www.maaslandgroep.nl
11
260123
7.2 INBOUW MONTAGE (PROFIEL)
1. Cutting the mortice
Referring to the product dimension drawings, a mortice is cut into the door frame to fit
the lock and a mortice is cut into the door leaf to fit the strike. Metal doors and frames,
being hollow, often only require a single rectangle cut-out to accommodate the lock face
plate or strike plate. For these installations lock and strike can be installed flush using
fitting tabs (available separately).
It is crucial to ensure that the mortices in the door leaf and frame are aligned vertically
and horizontally when the door is closed as this aligns the bolt pin to the strike opening
and also the strike magnet to the locks internal door position sensor.
Ensure that the final gap between the lock face plate and strike plate once it is installed
will be no more than 6mm.
2. Wiring the lock
Feed the wires out of the hollow chamber of the frame and a connection can be made to
the supplied wire loom which in turn plugs into the lock.
Refer to the Wiring section of this document for detailed instructions on wiring.
3. Setting the operating mode
Ensure the operating mode switch is positioned to the required state, Fail Safe or Fail
Secure.
Refer to the Operating Mode section of this document for detailed instructions on wiring.
4. Fitting the lock and strike plate
The lock can be placed into the door frame cutout, ensuring that the wiring integrity is
maintained, and then secured in place with M5 machine screws (included with fitting
tabs). Please ensure the lock is the correct orientation as to pull the door into the door
jamb.
The strike is then placed into the door leaf cutout and then M5 machine screws (included
with fitting tabs) are used to secure it in place. Ensure the strike is oriented so that the
bolt hole aligns with the lock bolt.
ELEKTRISCHE SLOTEN
