12
12
Swim Spa
JETS AND AIR CONTROLS
Swim Area Jets
Swim sp jets are designed to produce a smooth
flow of water with high output to create a
consistent swim stream. Whether you want to
swim or walk/jog against the force of the jets,
you will find the flow of water deep enough
and swift enough to meet your individual
needs.
Hydrotherapy Area Jets
All spa jets are individually engineered
to provide a unique hydro-massage.
Depending on the model, your spa will have a
combination of the following jets.
Directional Jets
Positioned to focus on large muscle groups,
these jets deliver a concentrated, high volume
stream of water for a deep massage. Each jet
is fully adjustable, allowing users to set the
water flow to the most comfortable setting.
Nozzle can be rotated to target sore muscles.
Rotating Jets
Positioned to focus on muscle tension zones,
these jets deliver a spinning V-shaped water
stream for a gentle, pulsating massage. Each
jet is fully adjustable, allowing for comfortable
water flow settings for everyone to enjoy.
Euro Jets
Positioned in the foot well or shoulder areas,
these jets deliver a penetrating massage to
dissolve tension. This jet may be the entry
point for ozone produced during automatic
filtration and therefore it is not adjustable.
Note: Ozone production is stopped when
functions are activated on control panel.
Cleaning or Replacing Jets
Hard water can cause calcium/mineral
buildup that can restrict or bind the jets. A jet
consists of a face plate and a nozzle. Rotate
these parts weekly and remove/clean monthly
to ensure free movement.
NOTE: It is not necessary to drain the spa to
clean or remove the jets.
Rotating Jets
• Rotate the jet face left and right
• Return face plate to full open position
• Turn the jets on high speed
• Twist the nozzle left and right
• Rotate the nozzle in the socket
NOTE: If the jet insert disengages from the
spa housing, see steps to reinstall below.
Cleaning Jets
• To
REMOVE
the jet insert, use the palm of
your hand to exert pressure on the face of the
jet. Turn counterclockwise until the jet ‘clicks’.
Gently pull the jet assembly from the housing.
• To
CLEAN
the jet insert and housing, use a
pressurized hose and spray the inside of the
jet. Soak the jet in a diluted spa cleaning
solution, rinse. Wipe the inside of the housing
to remove any debris.
• To
REINSTALL
the jet, line up the tab on
the backside of the barrel with the groove in
the body. Use the palm of your hand to gently
tap the jet until it snaps into position.
Summary of Contents for DT6
Page 54: ...54 54 Swim Spa NOTES...
