38
38
Swim Spa
3. The filter should be drained, and the
cartridge removed and cleaned.
4. Check to see that there is no water in the
heater element chamber.
5. Clean your swim spa as directed in the
following two sections on this page.
6. Cover your swim spa with a water-
shedding, impenetrable cover.
7. For further information on blowing out
the plumbing lines and winterising
procedures, contact your local dealer.
Swim Spa Cabinet Care
The swim spa series cabinets are made of
Duramaax™, a high quality alternative to wood
that is virtually maintenance free, requiring
no staining, sealing, or waxing.
To clean the swim spa cabinet, rinse dirt and
dust regularly with clear water. To remove
stubborn dirt, grime, and mild discoloration,
wash with a mild detergent and warm water.
Swim Spa Surface Care and Cleaning
Your swim spa shell surface is made of acrylic.
A minimum amount of care and cleaning will
keep it looking new for years.
Use a spa cleaner for residue and lime buildup
at the water level. It may be necessary to lower
the water level 1-2 inches (2.5-5 cm) before
cleaning to avoid polluting the swim spa.
Cleaner can be applied to the acrylic surface
with a soft cloth and wiped clean. Use a non-
abrasive mild dish washing detergent such as
Ivory®Liquid. Rinse well and dry with a clean
cloth.
NOTE: Do not allow the acrylic surface to
come in contact with products such as
acetone (nail polish remover), nail polish,
dry cleaning solution, lacquer thinners,
gasoline, pine oil, orange oil, citrus based
cleaners, etc.
Remove dust and dry dirt with a soft, damp
cloth. Clean grease, oil, paint and ink stains
with isopropyl (rubbing) alcohol diluted with
water. Avoid using razor blades or other sharp
instruments that might scratch the surface.
Underwater LED Lights
The underwater LED light assemblies are
serviceable from the inside the swim spa
cabinet. Remove the side panel and insulation
closest to the light; locate the bracket that
holds the LED assembly. Turn the LED Holder
90 degrees counter-clockwise; remove from
bracket. Pull bulb straight out and replace.
Insert LED holder back into bracket and turn
90 degrees clock-wise to secure.
Bluetooth/MP3 Audio System Option
CAUTION: Audio/MP3/Cell Phone/Portable
Electronic Devices
Many consumers own some form of portable
electronic device, and some spas come
equipped with systems designed to interface
with these devices. It is important to protect
a spa’s audio equipment and your portable
electronics by following a few simple
procedures:
- Always turn the volume down on your
portable electronic device before connecting
it to the spa audio system.
- Do not attempt to handle any portable
electronic device with wet hands.
- Inspect any area for moisture before setting
your portable electronic device in or on it.
Never use abrasive cleaners.
Protect Swim spa finish - always keep cover
on the swim spa when not in use.
Summary of Contents for DT6
Page 54: ...54 54 Swim Spa NOTES...
