E
n
g
lis
h
F
ra
n
ça
is
18
MAAX SPAS PERFORMANCE SERIES
Temperature
The maximum set temperature is 104
°
F
(40°C) and the minimum set temperature is
80
°
F (26°C). The current water temperature
or, if the pump has not been running, two
dashes, will show on the display. If dashes are
displayed, you must first start the pump by
pressing the
JETS 1
pad. Wait until the water
temperature is displayed (approximately 2
minutes). The set temperature of your spa
may easily be increased or decreased at
any time using the
WARM
or
COOL
pads.
When either of these pads is touched, the
set temperature will be displayed in the LCD
window. Each successive touch will change
the set temperature 1
°
F (0,5°C) in the chosen
direction. After 3 seconds the LCD will auto-
matically display the water temperature or
dash lines.
If the spa is set in
Standard
mode or in a
filtration cycle, adjusting the set temperature
may result in activating the heater. When
the heater is operating, the heat icon will be
displayed in the LCD.
JETS 1
Touch the
JETS 1
pad to activate the primary
filtration pump. The sequence of the jet
action is:
1 touch = Low therapy jets
2 touches = High therapy jets
3 touches = Off
JETS 2
Touch the JETS 2 pad to activate the therapy
pump. The sequence of jet action is:
1 touches = High therapy jets
2 touches = Off
The low speed operation of Pump 1 is timed to
automatically turn off after two hours of opera-
tion. The high speed operation of Pump 1,
and the low and high speed operation of
Pump 2, is timed to automatically turn off
after 15 minutes of operation.
NOTE: Pump 1 will automatically operate
in low speed whenever the spa calls for
a filtration cycle or heat. When this auto-
matic activation occurs, the low speed of
Pump 1 cannot be turned off; however, all
other control functions can be activated.
Temperature Lock
Once you have set the desired water
temperature, you may lock-in the new
setting to prevent unauthorized
temperature adjustments to your spa.
To lock the set temperature:
Touch
WARM
or
COOL
, then touch
TIME
,
JETS 1
and
WARM
within 3 seconds. The ‘TL’
indicator will light when the set temperature
is locked.
Temperature Unlock
To unlock the temperature, touch either
WARM
or
COOL
, then touch
TIME
,
JETS 1
,
and
COOL
within 3 seconds. The ‘TL’ indicator
light will go out when the set temperature
lock is cleared.
Panel Lock
To help prevent unauthorized use of your
spa, the control system has a unique panel
locking system. To lock the panel, touch
TIME
,
JETS 1
, then
WARM
within 3 seconds.
When locked, the ‘PL’ indicator light will be
on. Except for the time button, everything
will be frozen. When the control panel lock
is engaged, all automatic spa functions will
operate normally but cannot be altered.
