BODYWRAP WHIRLPOOL
SYSTEM ASSEMBLY AND
OPERATION GUIDE
A careful check of the whirlpool system
should be conducted upon receipt of the
unit. The basic whirlpool configuration is
shown in Figure 1. A system with an in-line
heater is shown in Figure 2.
If the unit has a factory-fitted:
!
Alternate pump location
,
refer to the
Supplemental Assembly
information packaged with the accessory
items for additional item checks before
continuing. Notify your supplier immediately if
any questions or problems are encountered
during this process.
DO NOT INSTALL UNIT WITHOUT
FIRST ADDRESSING QUESTIONS
WHICH ARISE DURING THE
INSPECTION!
Basic Whirlpool System Check
"
Check wire lead at on/off button and at
control box for secure attachment.
"
Check system to ensure all trim is in
place and for finish ordered.
Whirlpool System with Mounted In-
Line Heater Check
"
Check for factory installed in-line heater
option mounted on pump.
Basic Module Check
An individual check list is included in the
installation guidelines packaged with the
module. Refer to the listed publication for
further information before continuing.
Framing and Installation Requirements
Framing and dimensional requirements for
the module are included in the installation
guidelines packaged with the basic unit.
Refer to the unit installation guidelines for
further information before continuing.
The basic whirlpool system is produced
with the pump secured to the unit base and
with the complete system assembled at the
factory.
WARNING!
ADEQUATE ACCESS MUST BE
PROVIDED AT THE PUMP LOCATION.
Installation Guidelines
Inspection Guidelines
Page 2
0511
10023064
Air Control Knob
(2 per unit)
Wire
(Factory Connected
At On/Off Button &
Control Box)
Plug-In Control Box
On/Off Button
Jet Supply Line
Suction Line
Factory Mounted
Single-Speed
Pump
Electrical Supply Cable
With Attachment
Plug End.
Factory Mounted
Unit Base
Factory Installed
System Piping
Figure 1 - Basic Whirlpool System
(Typical Tub Illustrated)
Figure 2 - Whirlpool System With
In-Line Heater
(Factory Installed Option)
Jet Supply Line
Factory Mounted
In-Line Heater
Suction Line
Electrical Supply Cable With
Attachment Plug End.
(In-Line Heater)
Electrical Supply Cable With
Attachment Plug End.
(Pump/Motor)
Factory Mounted
Single-Speed Pump
Jet Supply
Line
