24
24
Swim Spa
1 cannot be turned off ; however, all other
control functions can be activated.
MODES OF OPERATION:
In the standard confi guration your spa can be
switched among
Standard, Economy,
and
Sleep modes
by touching the
TEMP
pad and
then the
LIGHT
pad. If your spa is in the
Standard mode
,
The low speed Pump 1 and the heater will
come on automatically to maintain the set
temperature of the water. The pump will
circulate for approximately two minutes
several times throughout the day to sample
water temperature. If your spa is set in
the
Economy mode,
The heater will operate
ONLY
during the
fi ltration cycles. If your spa is set in the
Sleep mode,
The spa will heat to within 20°F (11°C) of the
set temperature only during fi lter cycles.
The selected mode will be displayed in the
LCD window of the control panel.
When in
Standard mode
, the letters ‘
ST’
are displayed briefl y, followed by the water
temperature. When in
Economy mode
, the
letters ‘
EC’
are displayed alternately with the
water temperature. When in
Sleep mode
, the
letters ‘
SL’
are displayed alternately with the
water temperature.
Setting the Time and Filtration Cycles
You can decide when your fi lter cycles start
and you also have choices on how long they
run.
Preset Filter Cycles.
The spa control system
is designed with two fi lter cycles. The fi rst
fi lter cycle turns on 6 minutes after power is
supplied to the spa. The second fi lter cycle
turns on 12 hours later. Filter cycles are pre-set
for a two hour duration.
Note: To properly clean and maintain spa,
a total fi lter time of at least four hours per
day is recommended. If an ozonator is
installed, 6 hours is recommended.
Changing Filter Cycle Start Time
The start/stop times of the fi lter cycle begin 6
minutes after the spa set time is established.
Set time is based on the time of day that
the spa is powered up. Set time may only be
changed by disconnecting power from the
spa and re-connecting it at the desired start
time. For example, if you want the fi lter cycle
to begin at
9:00 PM
, turn off the spa breaker
and turn it back on at
8:54 PM
(remember
the 6 minute wait period). The cycle will begin
at
9:00 PM
and will repeat beginning at
9:00
AM
. Each cycle will run for the prescribed
number of hours.
Changing Filter Cycle Duration
The duration of a fi lter cycle can be set in hour
increments of 2, 4, 6, 8, or continuous. For
example, a 2 hour cycle will complete once
every 12 hours for a total of 4 hours per day.
The amount of time needed to fi lter you spa
will depend on usage and ambient conditions.
You will need to program you fi lter cycles
based upon your personal use.
To change the duration of the fi lter cycles
touch the ‘
TEMP’
pad and then touch the
‘JETS’
pad. Touch the ‘
TEMP’
pad to adjust
the cycle duration to the desired setting. After
each press, the duration of the cycle will be
displayed in the LCD window as follows:
F2
2 Hours for each cycle, 4 hours per day
F4
4 Hours for each cycle, 8 hours per day
F6
6 Hours for each cycle, 12 hours per day
Summary of Contents for xstream
Page 1: ...Owner s Manual Swim Spas ...
