11
2.2 temperature control
• Connect the freezer to power supply. The POWER indicator (the
green light) will shine. The RUN indicator (the red light) will shine
when the compressor is running.
• The temperature of the chamber is adjusted through the thermo-
stat knob. The numbers 1, 2, 3, 4, 5, 6, do not mean a specific tem-
perature, the lower the number is, the higher the temperature in-
side will be and vice versa.
• When the thermostat knob is turned to HI the freezer will enter
into fast freeze mode, and FAST FREEZE indicator (the yellow light)
will shine.
6
POWER
RUN FAST FREEZE
HI
5
4
3
2
1
The illustration above is only for reference. The actual configuration
will depend on the physical product or statement by the distributor.
2.3 location of the freezer
• Keep away from heat and avoid direct sunlight.
Do not place the freezer in moist or watery places
to prevent rust or reduction of insulating effect.
• Before using the freezer, remove all packaging
materials including bottom cushions and foam
pads and tapes inside the freezer, tear off the
protective film on the door and the freezer body.
• The freezer should be placed in a well-ventilated
indoor place; the ground shall be flat, and sturdy.
• The top space of the freezer shall be greater than
70 cm, and the distances from both sides and
backside shall be more than 20 cm to facilitate
heat dissipation.
