mabe FMM200UESX0, Instruction Manual

6

testing

1. Clean the freezer with lukewarm water and detergent,and wipe dry.

  Note: Electrical components should be cleaned with a  

dry cloth.

2. Turn the thermostat knob to the “2” position, and plug the freezer into  
  the wall outlet.The compressor will begin to run.
3.  Check, after 30 minutes of operation, to ensure that the freezer is cold.

temperature control

CAUTION:

 • BEFORE PLUGGING IN

  YOU MUST CHECK THAT YOU HAVE A SOCKET WHICH  

  IS COMPATIBLE WITH THE PLUG SUPPLIED WITH THE 

   FREEZER.  IF NOT SEE THE SECTION CALLED ELECTRI- 

   CAL INFORMATION ON 

PAGE 9. 

• BEFORE SWITCHING ON!
  DO NOT SWITCH ON UNTIL FOUR HOURS AFTER     

  MOVING THE FREEZER.

Before storing foods in your Freezer, turn the Freezer on and wait for 24 
hours, to make sure it is working properly and to allow the Freezer to fail to 
the correct temperature. 

1. The temperature control (thermostat knob

，

turned by coin) is located  

  near the top of the unit.
2.Turning the thermostat knob adjusts the temperature of the freezer.

  warmest and setting “4” is the coolest.
4. The factory recommended setting is “2” for normal operating   

  conditions.

1

2

3

4