2
10 cm.
10 cm.
5 cm.
3
Before connecting your refrigerator
general instructions
Remove the bases, packaging and accessories. Remove the adhe-
sive tape residue with a cloth soaked in water and neutral soap.
Choose the location of the refrigerator. This area should be kept
clean and dry to avoid rust.
placement
Allow the following minimum space to ensure adequate air
circulation, especially if the appliance is going to be fixed to the
wall: 5 cm on each side, 10 cm at the back and 5 to 10 cm on
top.
Do not install the refrigerator near heat sources like stoves, radiators,
or in direct sunlight, as this will cause it to overwork and be less
efficient, thereby increasing its consumption of electrical energy.
Do not lean it against a wall. By complying with this , you will be
ensured of the correct positioning of the product, preventing your
Refrigerator components from directly coming into contact with
walls or furniture, thereby avoiding disagreeable noise.
leveling
Use the two leveling screws to level the refrigerator.
Insert and adjust them so that they rest firmly on the floor.
The front of the refrigerator should rest a little higher than the
rear which should lean slightly backwards, thereby facilitating the
automatic closing of the doors and preventing temperature loss.
The grille is located inside your refrigerator. Please follow these
steps to assemble it:
1) Line up the gril
le´
s clips in a straight line against the holes in the
lower part of your refrigerator.
2) Once they are in position press in the direction of the
refrigerator
until the back of the grille reaches the refrigerator.
3) Ready! The gril
le
has been assembled.
27
1
Summary of Contents for MA021WI
