37
3
1
2
2. filling
To obtain the ice, pull the drawer towards you.
To refill the molds, remove the cassette sliding it out carefully.
Once the cassette is out of the freezer, turn the cassette
counterclockwise until is horizontal on a flat surface before filling
it.
The molds have a water level control. If you overfill them the
water will spill out.
With the knobs facing you, turn the cassette clockwise, the molds
will then be in a horizontal position.
Finally, put the cassette back into the Ice Factory. Move it on its
rails as far as it will go. And wait for the ice to be made. Be sure
to dry all excess of water from the bottom of the cassette before
putting it in freezer.
Turn or twist each knob in the clockwise direction until the ice
cubes fall into the drawer below. The drawer can only store the
ice from the three molds.
Make sure the ice drawer is empty before unmolding the next
bath of ice.
Clean the surface under the drawer at least once a week.
1.
2.
3.
4.
3. unmolding
easy ice
Some models have a device designed to make perfect ice, the Easy
Ice. This is located in the freezer door, leaving you more space inside
for your frozen foods.
note: When you use the Easy Ice it is very important that the freezer
shelves are in place.
“How to use your Easy Ice”.
1. remove
6.
5.
7.
Summary of Contents for MA021WI
