38
Fig. 6. Prior to carrying out the electrical con-
nection, please make sure that:
• The installation characteristics are such
as to follow what is indicated on the ma-
trix plate placed at the bottom of the hob.
• The installation is fitted with an efficient
ground connection, following the stan-
dards and law provisions in force. Ground
connection is compulsory in terms of the
law.
Should there be no cable and/or plug on the
equipment, use suitable absorption material
for the working temperature as well, as indi-
cated on the matrix plate. Under no circum-
stance must the cable reach a temperature
above 50°C of the ambient temperature.
Electrical hookup
If connecting directly to the mains power
supply, fit a multi-pole switch of a suitable
size for the rated capacity with a clearance
distance which completely disconnects the
power line under overvoltage category III
conditions, consistently with the rules of in-
stallation (the yellow/green ground wire must
not be interrupted). The plug or omnipolar
switch must be easily reached on the in-
stalled equipment.
If power supply cord is damaged, it must be
replaced by the manufacturer or service
agent or by qualified personnel in order to
avoid hazards.
Figure 6
Adaptation to various types of gas
(Fig. 7). If the appliance is preset for a differ-
ent type of gas than the available, proceed
as follows:
• Replace the injectors (Fig. 7) with the cor-
responding type of gas to be used (see
the "Specifications" table).
• To adjust the minimum, use a screwdriver
on the valve screw (Fig. 8) after turning
the valve to its minimum position. For L.P.
gas (butane/ propane) screw tight.
Figure 7
Only C3 crown
1. Cord clamp
2. Yellow/Green
