- 16 -
Phase 1
- Check that the screws used that are not supplied with the
product are suitable for the type of object.
- Position the fixing template surface B on the lower part of
the shelf (Fig.8), (considering the minimum distance from the
cooker top).
- Make 6 holes in the cabinet shelf respecting the measurements
indicated (Fig.7).
- Fix the 4 screws A (Fig.9B) without tightening them completely.
- Position the hood under the cabinet, push towards the wall so
the screw heads fully engage in the slots, tighten/fasten the 4
screws A and fix it definitively using the 2 safety screws B.
Installation
Phase 1
Mounting the hood in the lower part of the cabinet 8.2
This product can be installed in 2 different ways:
fig.9B
fig.8
fig.7
Summary of Contents for PVUS930
